Posted by Dave on April 18, 19101 at 07:36:35:
I need help with an 386 Hard Drive. We are trying to replace a Conner CP-3024 Hard Drive with a Western Digital WD 93044. This is in a processor in a N/C Control. The Western Digital has supposedly been configured for the application. Before the Hard Drive was configured it worked in the controller but as a PC application. When we rty to boot from a DOS 5. Disk an error message comes up as "NON SYSTEM DISK". We were able to copy the DOS files to the hard drive but the system will not boot from the original system disk, a DOS boot disk or the hard drive. Any suggestions?