Posted by Bob on September 07, 19101 at 21:57:02:
In Reply to: Scci ID posted by Jesse on November 01, 19100 at 04:41:06:
: I bought this old hard drive case off E-Bay and swapped a larger Quantum drive to it. The problem I see is the Rodime case had a SCCI selector switch on the back but the Quantum drive doesn't have a 6 prong port for the wire. I'm pretty sure that is what the wire is for. My question to you is how do I set the SCCI ID from this set up?
Jesse,
You could set the ID with jumpers on the drive and not use the switch on the case at all, but you would not be able to change the ID without opening the case. The 6-prong connector for the switch is probably intended to go over the same pins that would be used for installing ID jumpers on the drive, so it should work with lots of different models. Sometimes the contacts can be removed from the connector body and pushed onto the pins if they have a different layout.
Bob